FIELD HUB

PROCESS INTELLIGENCE

What do you need to solve?

Choose an application to find the right measurement technology.

Milktronics support available

Measurement solutions

Food, beverage & wastewater
01

Turbidity & fat

Phase transitions, CIP returns and product recovery.

02

BRIX

Dissolved solids across RO, process and drain lines.

03

BOD / COD / TSS

Real-time wastewater insight without waiting for the lab.

04

Foam control

Ultrasonic foam collapse without chemical additives.

05

Viscosity

Continuous and at-line product consistency measurement.

06

Flow & level

Process, tank and open-channel measurement.

SOLUTION FINDER

Describe the measurement point

RECOMMENDED STARTING POINT

Inline turbidity meter

Best suited for fast product-to-water transitions, CIP return detection and product-loss reduction.

  • Confirm process connection and pipe diameter
  • Avoid installation immediately next to a pump
  • Define the switching threshold during commissioning

REQUEST A QUOTE

Tell us about your process

The right details help Milktronics select the range, connection, output and installation package without delay.

Contact & application

Process conditions

Your email app will open with a complete request addressed to Milktronics. Attach process photos, drawings or specifications before sending.

PAYBACK CALCULATOR

Turn product loss into a business case

ESTIMATED PAYBACK4.5 weeks

$63,700annual savings

$5,308monthly savings

Planning estimate only. Actual savings depend on process conditions and operating practices.

FIELD TOOLKIT

Fast checks before calling support

Turbidity reading is noisy ＋
  1. Check whether the sensor is close to a pump or restriction.
  2. Confirm the pipe stays completely full.
  3. Look for air bubbles or turbulence in the sight glass.
  4. Compare readings with the pump stopped, if safe.
  5. Consider relocating the sensor at least 6 ft from the pump.
Reading does not return to zero ＋
  1. Inspect and clean the optical lens.
  2. Confirm the tri-clamp is not plugged.
  3. Remove the sensor and test it in clean water.
  4. Then test with a known product, such as 2% milk.
UV BOD/COD meter is offline ＋
  1. Check power to the sensor and controller.
  2. Inspect junction boxes for water intrusion.
  3. Verify communication wiring and Modbus settings.
  4. If temperature exceeded 122°F, allow the LED to cool and restart automatically.
Before commissioning ＋
  1. Confirm 24 VDC power and panel space.
  2. Confirm 4–20 mA or Modbus wiring is ready.
  3. Verify the process connection and mounting hardware.
  4. Prepare representative samples and lab access.

SERVICE REQUEST

Give us a clear picture of the issue

This opens your email app with the information filled in. Add photos before sending.

TECHNICAL RESOURCES

Documents for selection and installation

Use Milktronics' product library for current customer-facing documents.

ALL PRODUCTS

Download center

Browse current datasheets, brochures, drawings and manuals.

Open library ↗ TURBIDITY

VOM phase sensor

High-range sanitary turbidity and phase-transition measurement.

Product resources ↗ REFRACTOMETRY

UR24 BRIX

Inline concentration measurement for dairy and food processes.

Product resources ↗ WASTEWATER

Inline BOD / COD

Real-time organic-load monitoring and process control.

Product resources ↗
Can’t find the document?Contact an application engineer at 352-602-6404.
Request a document